Bemo61
Complete Newb
Reged: 08/02/09
Posts: 18
Loc: Fayetteville GA.
|
|
Morning everyone...I'm ready to start removing the baffels from a set of stock tapered exhaust from a 07 TBA.When looking in the inlet side/header side I can see a small dowel pin holding in what appears to be some kind of mesh.Should this stay in, or be removed also? What is it,I didn't think the 07 TBA had a catalytic converter.Any ideas? By the way ,I'm removing "2" baffels.Thanks Again! 
--------------------
'07 America "Arrest Me Red" & Black! Tighten It Till It Strips,Then back-off a 1/2 turn.
|
NIbiker
Learned Hand
Reged: 01/11/05
Posts: 1339
Loc: N Ireland
|
|
I think they are cats, but I dont remember a pin thing. (my 07 had cats) I drilled from the exit of the pipes with an extended hole saw, 3 sets of baffels I think, I then drilled through the cats from the front later, removing the cats made no difference to the noise that I could tell so you could leave them in.
|
NIbiker
Learned Hand
Reged: 01/11/05
Posts: 1339
Loc: N Ireland
|
|
Sorry for quality.
Cats and baffels drilled out.
|
Bemo61
Complete Newb
Reged: 08/02/09
Posts: 18
Loc: Fayetteville GA.
|
|
Thanks NIbiker...I Think for I'll leave the cats in place and remove them later if I deceide to drill out the third baffle. Ride Safe! 
--------------------
'07 America "Arrest Me Red" & Black! Tighten It Till It Strips,Then back-off a 1/2 turn.
|
Previous
Index
Next
Threaded
Edit
Reply
Quote
